Amana PACKAGE TERMINAL Especificaciones Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 12
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5
6
ACCESSORIES
Wall Sleeve (42” wide x 16-1/16 high x 13-3/4” deep)
Standard insulated wall sleeve fits all Amana Packaged
Terminal Units. Shipped separately to allow installation
during construction.
Outdoor Grilles
Available in stamped aluminum and an attractive ex-
truded aluminum architectural grille for application with
WS900B wall sleeve. The architectural grille is available
in anodized natrual, 3 stock colors and custom colors to
blend with the building exterior. CB=Clear, DB=Dark
Bronze, ZB=Driftwood, WB=White, SB=Special (Custom)
Color
Remote Temperature Sensor
Allows inexpensive, low voltage temperature sensing on
internal wall for more accurate temperature control.
Hard Wire Kit (not shown)
Used to permanently wire to chassis when standard sub-
base and power cord are not utilized.
Subbase Kit
The fully skirted subbase conceals wiring while provid-
ing strong support, if needed. Plug-in receptacle and
field wiring access speeds installation. Electrical acces-
sories such as fuse holders, circuit breakers and dis-
connect switches meet N.E.C. requirements.
Fuse Holder Kit (not shown)
Cartridge style fuses can be installed in fuse holder for
use in subbase or chassis. Available in 15, 20 and 30
amp. (Included on 265v unit).
Circuit Breaker Kit (230/208v only)
The circuit breaker kit, available in 15, 20, 25 or 30 amp,
can be used with Amana's subbases. It gives overcurrent
protection and its location allows turning unit on or off
without tools.
Power Disconnect Switch (not shown)
The PSHW**A power disconnect switch can be used for
265 or 230/208 volt physical disconnect where required
by local codes. The switch is rated at 30 amp capacity.
The switch is for use with Amana's standard subbases
or PTPWHWK4 Hard Wire Kit.
Condensate Drain Kit
Attaches to the wall sleeve base pan for controlled inter-
nal or external disposal of condensate
.
PTSB320C 230/208V 15/20A
PTSB330C 230/208V 30A
PTSB420C 265V 15/20A
PTSB430C 265V 20A
FHK315C 230/208V 15A
FHK320C 230/208V 20A
FHK330C 230/208V 30A
PSHW03A 230/208V
PSHW04A 265V
WS900B Wall Sleeve
PTPWHWK4 Hard Wire Kit
Skirting
Skirting
Le veling Le gs
Optional
Fuse Holder
Location
Optional
Power Switch and Ci rc uit Breaker
Location
Power Re ceptacle
Subbase Box Assembly
42"
13-3/4"
16-1/16"
Gasket
Cover
Plate
1/2" OD
Drain Fitting
CBK3**C Circuit Breaker Kit
DK900-1
Condensate
Drain Kit
Standard Outdoor Grille
SGK01B Single Pack
SGK10B Ten Pack
Architectural Grille
AGK01*B Single Pack
AGK10*B Ten Pack
RTS01
Remote
Temperature Sensor
®
60
70
80
90
60
70
80
90
®
AIR
CON DIT IONING
Thermostats
The following thermostats offer remote control.
Heat Stages Cool Stages Programmable Shape
D9807605 2
1 Yes Rectangle
D9945801 2
1NoRectangle
D6853511 1
1NoRectangle
C5200609 1
1 No Round
Note: Thermostats listed above are manual changeover
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios