
SS-DPTAC www.amana-ptac.com 5
SPECIFICATION SHEET
PTAC ACCESSORIES (CONT.)
SUB-BASE KIT
The fully skirted sub-base con ceals wiring while pro vid ing
strong support, if needed. Plug-in re cep ta cle and fi eld-
wiring access speeds in stal la tion. Electrical ac ces so ries,
such as fuse holders, circuit breakers, and dis con nect
switches meet NEC re quire ments.
PTSB320E 230/208V 15/20A
PTSB330E 230/208V 30A
PTSB420E 265V 15/20A
PTSB430E 265V 25A
PTSB000E Non-electrical
Skirting
Skirting
Leveling Legs
Optional
Fuse Holder
Location
Optional
Power Switch and Circuit Breaker
Location
Power Receptacle
Subbase Box Assembly
HARD-WIRE KIT (NOT SHOWN)
Used to permanently wire to the chassis when a stan dard
sub -base and power cord are not used.
PTPWHWK4 Hard-Wire Kit
POWER DISCONNECT SWITCH (NOT SHOWN)
The PSHW**A power-dis con nect switch can be used for
265-volt or 230/208-volt physical dis con nect, where
re quired by local codes. The switch is rat ed at a 30-amp
ca pac i ty and for use with Amana
®
brand standard sub -
bases or PTPWHWK4 Hard-Wire Kits.
PSHW03A 230/208V
PSHW04A 265V
FUSE HOLDER KIT
Cartridge-style fuses can be installed in the fuse hold er
for use in the sub-base or chassis. Avail able in 15-, 20-,
and 30-amp sizes. (included on 265-volt unit).
FHK315C 230/208V 15A
FHK320C 230/208V 20A
FHK330C 230/208V 30A
CIRCUIT BREAKER KIT (230/208V ONLY)
The circuit breaker kit, available in 15-, 20-, or 30-amp
sizes, can be used with Amana
®
brand sub -bases. It gives
over cur rent protection, and its location al lows you to
turn the unit on or off without tools.
CBK3**C Circuit Breaker Kit
DUCT EXTENSION KIT
Extends air distribution to an adjoining room. Con sists
of a main duct for the room of or i gin and an ex ten sion
duct to reach the ad join ing room and ter mi nal duct.
PTDK01A allows for the new B Series unit to work with
the A Series duct kits.
MDK02B Main Duct
EDK02B Extension Duct
TDK02 Terminal Duct
PTDK01A Transition Duct Only
See below.
TRANSITION BAFFLES
Main Duct Kit
Extension Duct Kit
Terminal Duct Kit
POWER VENT KIT (NOT SHOWN)
Installation of Power Vent increases CFM up to
ap prox i mate ly 95. Vent door will automatically close
when unit fan is off.
PVK3A 230/208V
PVK4A 265V
POWER DOOR KIT (NOT SHOWN)
Vent door will automatically open when unit fan is on.
PDK3A 230/208V
PDK4A 265V
CONDENSER BAFFLE KIT
For use on non-baffl ed grilles. These defl ectors di rect the
air to ward the cen ter and away from the inlet to pre vent
re cir cu la tion of the hot con dens er air.
DGK1B Condenser Baffl e Kit
Basepan
Condenser
Condenser Baffles
Comentarios a estos manuales